Posligne ODP 200, Technical Manual, Page: 69 / 84

ODP 200 Technical Manual
69
[Name]
Set relative vertical print position in page mode
[Format] ASCII GS
＼
nL nH
Hex 1D 5C
nL nH
Decimal 29 92
nL nH
[Range]
0
≤
nL
≤
255
0
≤
nH
≤
255
[Description] Sets the relative vertical print starting position from the current position in page mode.
This command sets the distance from the current position to [(
nL
+
nH
x 256) vertical or
horizontal motion unit] inches.
[Details] This command is ignored unless page mode is selected.
When pitch N is specified to the movement downward:
nL
+
nH
x 256 = N
When pitch N is specified to the movement upward (the negative direction),
use the complement of 65536.
When pitch N is specified to the movement upward:
nL
+
nH
x 256 = 65536 – N
Any setting that exceeds the specified printing area is ignored.
This command function as follows, depending on the print starting position set
by ESC T:
℃ When the starting position is set to the upper left or lower right of the printing, the
vertical motion unit (
y
) is used.
℃ When the starting position is set to the upper right or lower left of the printing area, the
horizontal motion unit (
x
) is used.
The horizontal and vertical motion unit are specified by GS P.
The GS P command can change the horizontal (and vertical) motion unit.
However, the value cannot be less than the minimum horizontal movement amount,
and it must be in even units of the minimum horizontal movement amount.
[Reference] ESC $ , ESC T , ESC W , ESC
＼ ＼ ＼ ＼
, GS $ , GS P
GS a
n
[Name]
Enable/Disable Automatic Status Back (ASB)
[Format]
ASCII GS a
n
Hex 1D 61
n
Decimal 29 97
n
[Range]
0
≤
n
≤
255
[Description]
Enables or disables ASB and specifies the status items to include, using n as follows:
Bit Off/ On Hex Decimal Status for ASB
0 Off 00 0 Drawer kick-out connector pin 3 status disabled.