ODP 200 Technical Manual
50
ESC c 3
n
[Name]
Select paper sensor(s) to output paper-end signals
[Format]
ASCII
ESC
c
3
n
Hex
1B
63
33
n
Decimal
27
99
51
n
[Range]
0≤
n
≤255
[Description]
Selects the paper sensor(s) to output paper end signals.
Each bit of
n
is used as follows:
Bit
Off / On
Hex
Decimal
Function
Off
00
0
Paper roll near-end sensor disabled
0
On
01
1
Paper roll near-end sensor enabled
Off
00
0
Paper roll near-end sensor disabled
1
On
02
2
Paper roll near-end sensor enabled
Off
00
0
Paper roll end sensor disabled
2
On
04
4
Paper roll end sensor enabled
Off
00
0
Paper roll end sensor disabled
3
On
08
8
Paper roll end sensor enabled
4 – 7
-
-
-
Undefined
[Details]
It is possible to select multiple sensors to output signals.
Then, if any of the sensors detects a paper end, the paper end signal is output.
The command is available only with a parallel interface and is ignored with a serial interface.
Sensor is switched when executing this command. The paper end signal switching
be delayed depending on the receive buffer state.
If either bit 0 or bit 1 is on, the paper roll near-end sensor is selected as the paper sensor
outputting paper-end signals
If either bit 2 or bit 3 is on, the paper roll end sensor is selected as the paper sensor outputting
paper-end signals.
When all the sensors are disabled, the paper end signal always outputs a paper present status.
[Default]
n
= 15