3 - 5
TM
CHAP. 3
OPERA
…
Operation Method
1.
Open the top cover, pull the adjust lever one notch from standard position
toward the operation panel side. When you cannot find standard position,
push the lever as far as possible toward the rear, then pull it by 2 notches
after having pressed it down. The lever is now in standard position.
2.
Mount the top cover.
3.
Set the printer for the validation print mode through control codes to the
printer. In this instance, the buzzer gives two short beeps.
4.
Make sure that the “ON LINE” LED is flashing.
5.
Align the right edge of paper with the right end of the tear bar then insert the
paper from the top in front of the tear bar.
6.
The printer starts printing about 1 second after the paper is loaded.
7.
When printing is completed, pull the paper upward and remove it from the
printer.
Note: When printing a roll paper, it is recommended to adjust the lever at
the same position as for validation printing.
Fig. 12 Validation printing
Summary of Contents for PP3000 Series
Page 1: ...TM Rev B PP3000 POS PRINTER MANUAL ...
Page 4: ......
Page 10: ......
Page 42: ...4 14 TM CHAP 4 TECHN ...
