Page 7
When to Replace Paper Roll
When the printer gives a paper out signal or a
red line appears on the thermal paper, it is
time to replace the paper roll. Do not wait till
the print engine is dragging the paper roll at
the very end. Remove the leftover and replace
the old paper roll with a new paper roll as
guided above to prevent the printer from
excessive paper dust and lower the possibility
of consequent paper jam.
CONNECTION
USB Connection (to Posiflex Pole Display)
The USB port of PP-6907 is a host interface to a Posiflex POS display
only, such as PD26UE.
LAN Connection
The LAN connector is an 8-PIN RJ45 type modular connector. Please use
a LAN cable of CAT 5 of a proper length to connect the LAN connector
on the printer to a LAN hub as appropriate. Please also note that, to enable
the LAN interface of the printer, open the setup window plate and adjust
the
DIP
switch position 2 to OFF, leaving the rest unchanged as
factory default setting.
Do not connect a peripheral device (cash drawer) to this port!
The
LAN port is 10/100 base-T compliant.
Wi-Fi Connection
To make a host terminal, such as a Android Smart Phone or Tablet,
wirelessly connect to the PP-6907, please set the network segment of the
host terminal to that of PP-6907, 192.168.192.XXX (1 ~ 254), in which its
Network prefix length is 24; for example, the default IP address of the PP-
6907 is 192.168.192.
168
, so the IP address of the host terminal should be
set to 192.168.192.
169
or the like, and its Network prefix length is
likewise 24. Then, adjust the hardware DIP switch position 2 to ON,
leaving the rest unchanged as factory default setting. In the aspect of Wi-
Fi connection to an Android Smart Phone, a tablet PC and the like, the PP-
6907 can work in infra mode only and connects to wireless devices
through an access point; thus, after the network segment of the host
terminal is set and the hardware DIP switch position 2 is adjusted to ON,
the host terminal wirelessly connects to the PP-6907.
Paper-out signal
