2
II. MODEL NUMBERS
Font Table Used USA/Europe USA/Japan
Rear Top Mount for TP series, Charcoal
PD302C
PD302CJ
Stand Alone Desk Top model, Ivory
PD303
PD303JPN
Rear Mount for TP7000 series, Charcoal
PD305C
PD305CJ
III. INSTALLATION
Before Installing PD302 & PD305:
Separate the main unit from its stand assembly. Consult a qualified
electronic engineer to prepare power for the PD302 or PD305 in the service
window on rear side of the main unit and then reassemble the touch terminal.
PD302 Specific:
1. Aim the bottom center cavity of PD302 series toward the
latch stub at rear of touch terminal main unit. Then aim both
metal and plastic hooks at rear of the PD302 series toward
the suitable ventilation openings on top rear of the main
unit. Please use a phillips head driver to fasten the screws
on the metal hook but not to overdo it so that the metal
hooks hold the ribs of the ventilation holes from inside.
2. Plug the DB9 female connector to the COM port with power DC supply
from the TP series. Please remove the COM1 terminator and save it at a safe
place for future use if COM1 is to be used for PD302.
3. Route the cable to go through the notch on back of the stand
assembly of touch terminal as indicated in the picture.
Reassemble the main unit and stand assembly.
(
Guidance for future un-installation:
Please use screw driver to release the
metal hook before removing PD302 from the ventilation holes.)
PD305 Specific:
Remove rear connect cover of the Posiflex TP7000 terminal per
instruction of the terminal. Fix PD305 to the opening accordingly.
PD303:
1. Adhere the two pieces of EVA tape on the metal plates at
bottom as indicated in picture at right. Peel off the protective
covers of the tape to stick PD303 series on a flat and clean
Metal Hook
Plastic Hook
