Part 6
Take PD-2601 out of its box and refer to
Pix. 3
that is a picture of the pole
display base unit (lowest part of the PD) with 2 enlarged portions to the right
and a slightly enlarged side view picture to the left to find 2 bottom locking
lugs
A’
; 2 short cylindrical locating bosses B’ to fit into I/O plate; and 2 plastic
screw bosses
C’
on side. Please note that the PD cable comes out of the bottom
end of the base tube yet in the illustration pictures the cable is eliminated for
sake of minimum visual confusion.
Insert bottom locking lugs
Turn the pole display base unit opposite to have the bottom locking lugs
A’
in
Pix. 3
facing left and now insert the 2 bottom locking lugs
A’
on base unit into
the 2 rectangular installation holes
A
on bottom of HT or PB chassis from the
right corner with the pole display slightly inclined to the left as in
Pix. 4
.
Please note that both bottom locking lugs
A’
should be completely inserted
and come out of the bottom plate of HT or PB system as emphasized by an
arrow in the enlarged portion.
Fit in locating bosses
Please always keep a gentle pressure at the bottom end of pole base (bottom
locking lugs
A’
) to the left (away from the sidewall of system chassis) when
moving the upper part of pole toward sidewall and matching the 2 short
cylindrical locating bosses
B’
into 2 round holes
B
in the I/O plate. Please refer
to
Pix. 5
to see the 2 locating bosses
B’
from inside of HT or PB system.
A
Pix. 4
A’