4 - 3
connector of CCBLA-141 to the I/O device of PC such as a HDD if
necessary.
5. Assemble the case of PC back.
Then referring to drawing below to complete the basic power and signal
cabling. Note the PC should remain OFF during the connection.
1. Connect the 4 pin telephone plug of CCBLA-411 to the 4 pin
telephone jack on the I/O plate of CCBLA-141 which has been
mounted as described above.
2. Insert the DC plug of CCBLA-411 into the jack at the bottom of the
base of PD in the same way as the power adaptor. Let the cables come
out of the bottom of PD2200 series through the opening at the back of
base so that the PD can stand securely.
3. Now the user may turn on the PC (and the PD when it is PD2200
series) for application unless the user wants to use PD for pass through
purpose (PD2200 series only).
3. Using power from POS system
for PD2201 series
This super convenient power supply method applies only to PD2201
when installed in a Posiflex PST POS system or PD2200B when connected to a
Posiflex POS system after proper setting for power in COM port. The power
connection is already done when the signal connection is completed.
4 pin Telephone
jack of CCBLA-141
COM port (9 pin serial port)
Both to bottom
of PD
9 pin D connector
of CCBLA-372
4 pin Telephone plug of CCBLA-411
Rear side of PC
