Part 5
CONNECT/DISCONNECT CABLES
After removal of the cable cover, the connector area will be accessible
then. Please disconnect every cable before separation of main unit and the
adjustable stand assembly. When later the main unit and stand assembly are to
be re-assembled for application, please connect all required cables to the
appropriate connectors. Please make sure that each connector is connected to
the right port with the correct orientation.
Damages due to incorrect
connection or orientation are not covered by product warranty!
Some connectors, such as the LAN connector and the cash drawer
connector have to be inserted until a click is heard. It is recommended that
connectors such as the external VGA connector, the LPT port connector and
the COM port connectors, be screwed into place once seated. If the COM1 port
must be used, the COM1 terminator that occupies the COM1 port must be
removed. However, when using the COM1 port, be sure to use devices that
provide proper hardware handshaking signals in order to keep the cash drawer
control features. A serial mouse is one example of a device that does not
support handshaking.
Adjust the slack of each cable and close the cable cover. Use the same
plastic latchkey that is used when removing the cable cover, but be sure to turn
it in the clockwise direction to lock the cover in place. Re-adjust the tilt angle
of the screen for best viewing.
SEPARATING MAIN UNIT
In order to settle the touch terminal properly in a point of sale system,
all the cable connections have to be routed through its base, the stand assembly.
Therefore, please press the lock/release button at the rear side to separate the
main unit from the stand assembly after all cables in cable cover disconnected.
For easy operation, it is most recommended to lay the system facing
down on front panel over a soft clean flat surface first, such as a piece of cloth
on the desk. Press the button and slide the stand assembly downward (as
viewed from the main unit) to detach the stand assembly away from the back
of the main unit could then be an easier operation. This approach can also be
Press the Lock/Release button
and slide the stand assembly
downward (as viewed from the
main unit) to detach it from the
main unit.
A soft clean flat surface, such as a piece of cloth on the desk.
Push this way
