2 - 3
please adjust in setup window the
switch positions both 1, and 2
to ON leaving the rest unchanged as factory default setting
.
3.
USB connection
The USB cable used to connect the USB interface printer
PP-7000IIUSB to the USB port of a host has a type A USB
connector at one end that is a more or less flat shape 4 pin
connector and a type B USB connector at the other that is a more
or less square shape connector. Insert the type B connector to the
USB connector at rear bottom of the printer and insert the type A
connector to a USB port of the host. Please set in setup window
the
same way as in serial connection, i.e. switch positions both
1, and 2 to OFF leaving the rest unchanged as factory default
setting
.
There are 2 stages of device driver installations and a port
setup procedure required for the USB interface printer. First is to
install PP-7000II USB Thermal Printer. When the PP-7000IIUSB
is connected and turned on to a host
running Windows, a message like the
right picture will pop up and the
“Add/New Hardware Wizard” (for Win98) or the “Found New
Hardware Wizard” (for Win 2000 or WinXP) will come up.
