7
B.
CONNECTING CABLES
1.
Serial connection
All the external connectors are in the recessed area at the
rear bottom for PP-7000-III. The serial connector is a 9-PIN D
sub Female connector at the right in the picture above. Apply the
male connector of RS232 cable to this port for serial application.
Please note that when serial connection is used, there must be no
cable connection at the parallel port on the printer. The default
protocol used in serial connection is 19200 bps, none parity, 8
data bits, 1 stop bit. Set in setup window the
switch positions
both 1, and 2 to OFF leaving the rest unchanged as factory
default setting
.
2.
Parallel connection
The parallel connector is a 25-PIN D sub Male connector at
the leftmost location in the connector area for PP-7000-III. Apply
the female end of the parallel cable at this port for parallel
application. Please note that when parallel connection is used,
there must be no cable connection at the serial port on the printer.
Please also note that to keep parallel interface in fast operation,
please adjust in setup window the
switch positions both 1, and 2
to ON leaving the rest unchanged as factory default setting
.
3.
USB connection
The Aura PP-7000-III series support two types of USB
interface input namely a Normal USB interface and a + 24V
Powered USB interface. The cable for normal USB connection
PP-7000U-III
PP-7000-III
