12
4.
Paper cutting
The paper advance after a protective cut is set to 12 mm. In
case the user uses direct cut instead of protective cut to have
something like a logo printed on top of each slip, it is also highly
suggested to print the logo and necessary paper feeding to make
12 mm paper advance right after each cut to prevent curling up
and jamming of paper front edge inside the paper exit slot.
5.
Wall mount application
In wall mount application, the paper near end sensor will
not have proper operation and it is suggested to set in the setup
window to have the printer to send busy only when input buffer is
full and not based on every off line signal.
