Page 18
For the switch position 2, it is recommended to place at Off. In this way, the
printer performs an automatic paper cut each time when the top cover is closed
(e.g. after paper roll loaded) with the printer in operating condition. However,
if it placing in ON, it will not automatically cut paper after top cover closed.
When switch position 3 set to “ON”, the paper will fully cut after paper printed.
If the printed-paper do not needs to completely cut, please set this switch to
“OFF” then the printed paper will be partially cut and left a tiny piece that user
needs to rip the printed paper. When the printer set to full-cut mode, please
notice that the paper should be take away immediately right after printed.
Otherwise, the last paper will cut again with the next printed-paper cut. Please
notice that when it place to ON, the paper will retract 14.5 mm before it start to
print.
For switch position 4
,
when it set to “OFF”, the paper will feed before cutting
when software does not define this point and there will be a further paper
feeding after cutting to prevent last 2 lines cutted. Before setting this switch to
“ON”, please make sure that your software will take care of enough paper feed
for printed lines cut prevention issue.
For switch position 5, if the switch is set to “ON”, the busy signal set to host
only when input buffer is full. When it is set to “OFF”, busy signal is sent to
host whenever the input buffer is full or an off line status occurs. Therefore,
signals including the paper near end detect will generate busy signal to the host.
Moreover, the printer will keep on beeping at Paper End (completely no paper)
till paper is replaced when S2-5 is “ON”. When S2-5 is “OFF”, the printer will
keep on beeping every 3 seconds at Paper Near End (still long paper in replace)
till paper is replaced.
For switch position 6 and when it is set to ON, the printer responds to a
carriage return command (CR code or 0Dh) with also a line feed (LF code or
0Ah) action. Then if the text editor always expresses the change to a new line
with both the CR and LF codes, there will be an extra line advance than
expected. However it works for some old editors that express the change to a
new line with only either one of the LF code or the CR code.
Switch position 7 defines the parity check regulation in serial interface.
In Aura-9000, it is selectable between even and none.
For switch position 8 can choice the handshaking method in serial interface.
When it is set to ON, the printer transmits an “XOFF” for busy and sends an
“XON” for not busy. When it is set to OFF, the printer signifies the busy status
