:: 26 BESEA
USER MANUAL ::
ENGLISH
USER MANUAL ::
ENGLISH
:: 27
BESEA
After finishing your dive start with undoing your weight belt.
Then undo in the following order crotch strap, waist belt, and one
shoulder strap. Let a buddy help you to lift off your Besea and
your cylinders and put it lying on the ground or on the deck.
It is strongly recommended to use the carrying handle for
transportation/carrying of the Besea, still having the cylinders
attached. Regulator hoses and demand valves can be secured
and protected during transportation as shown in the picture on
the left.
Dismount the cylinders from the harness.
Let water out from your Besea that may have entered the blad-
der during your dive. Inflate the bladder, either orally or by using
the inflator. With the Besea almost fully inflated, rotate it back
and forth a few times so that the entrapped water collects inside.
Then let the water out through the inflator, by holding the Besea
up side down, with the inflator at the lowest point and depressing
the oral inflation button.
Rinse your Besea in fresh water both internally and externally
after every dive. After seawater have been emptied as described
above, fill approximately 1-2 litres of fresh water into the bladder
via the inflator. Partly inflated, rinse the bladder internally and
then let the water out as described above
AFTER DIVE
No other maintenance procedures that you can do yourself other
than those described in section After Dive is needed. If your
Besea is heavily contaminated and dirty, or after your last dive
for the season, it is possible to wash the Besea in a washing
machine. Valves and inside PU bladder shall NOT be washed in a
washing machine. Unscrew all APRV:s and the inflator from the
bladder. Unzip the bladder and remove the inside PU bladder.
Tumble drying is prohibited.
MAINTENANCE
