:: 22 BESEA
USER MANUAL ::
ENGLISH
USER MANUAL ::
ENGLISH
:: 23
BESEA
If a wing is used with the harness, connect the quick
connector of the inflator feed hose to the inflator
mechanism.
Ensure you have adjusted the Besea size to fit perfectly (see
section size adjustment). Undo waistbelt buckle, crotchstrap
buckle and one shoulderstrap buckle. Hang the Besea on
your one shoulder, preferably on the side where you have no
instruments on your wrist, or APRV:s on your drysuit. Lean
forward and the pre-curved waistbelt will grab around your hips.
Then tighten the waistbelt, until you feel that you comfortably
can carry the load with your waistbelt/lumbar support only.
Finally, tighten the other shoulderstrap and adjust.
Put your weights into your weight pockets and lock the buckle.
DONNING
Do not dive with a Besea that is damaged, leaks air, or does not
function properly. Before each use inspect for proper operation,
leakage, or damage. Terminate any dive as safely and quickly as
possible if the Besea becomes damaged, leaks air, or does not
function properly.
Always perform a pre-dive and post-dive inspection of the Besea.
Have your dive partner perform a crosscheck as well. The pre-
dive and post-dive Besea examinations help identify equipment
problems before unsafe conditions exists.
Ensure you are using a regulator set at min/max working IP = 7
– 13 bar
Make absolutely sure your weight system is not entangled, and
can be dropped off freely.
PRE DIVE CHECKS
WARNING
WARNING
WARNING
WARNING
