POSBank miniQ, User Manual

Page: 51 / 95

-51-
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sector read/write. If your IDE hard drive supports block mode (which is the case for
most newer hard drives), select “Enabled” for automatic detection of the optimal number of block read/writes per sector that the drive can support.
IDE DMA Transfer Access
To Enable/Disable the IDE DMA transfer access.
OnChip Primary PCI IDE
The integrated peripheral controller contains an IDE interface with support for two IDE channels. Select “Enabled” to activate each channel separately.
IDE Primary/Secondary Master/ Slave PIO
The four IDE PIO fields allow you to set a PIO mode (0-4) for each of the four IDE devices that the onboard IDE interface supports. Modes 0 through 4
provide successively increased performance. In Auto mode, the system automatically determines the best mode for each device.
IDE Primary/Secondary Master/ Slave UDMA
Ultra DMA/33 implementation is possible only if your IDE hard drive supports it and the operating environment includes a DMA driver (Windows 95 OSR2 or
a third-party IDE bus master driver). If your hard drive and system software both support Ultra DMA/33, select Auto to enable BIOS support.
On-Chip Secondary PCI IDE
Enables the secondary IDE channel.
On-Chip Serial ATA
The chipset contains a SATA IDE interface with support for two IDE channels. Select Enabled to activate the primary IDE interface (Channel0). Select Disabled
to deactivate this interface. The options are: [Disabled], [Auto], [Combined Mode], [SATA Only].