System Installation
WADE-8079 User’s Manual
3-1
Chapter 3
System Installation
This chapter provides you with instructions to set up your system. The additional
information is enclosed to help you set up onboard PCI device and handle Watch Dog
Timer (WDT) and operation of GPIO in software programming.
3.1
Intel® Valleyview CPU
Intel® E3800 family CPU
3.2 Main
Memory
WADE-8079 provides 1 x 204-pin SO-DIMM sockets which supports 1333 MHz
DDR3L-SDRAM (1.35V) memory as main memory, non-ECC (non-Error Checking
and Correcting). The maximum memory can be up to 8GB. Memory clock and related
settings can be detected by BIOS via SPD interface.
Watch out the contact and lock integrity of memory module with socket, it will
impact on the system reliability. Follow normal procedures to install memory module
into memory socket. Before locking, make sure that all modules have been fully
inserted into the card slots.
3.3
Installing the Single Board Computer
To install your WADE-8079 into standard chassis or proprietary environment, please
perform the following:
Step 1
: Check all jumpers setting on proper position
Step 2
: Install and configure CPU and memory module on right position
Step 3
: Place WADE-8079 into the dedicated position in the system
Step 4
: Attach cables to existing peripheral devices and secure it
WARNING
Please ensure that mother board is properly inserted and fixed by mechanism.
Note:
Please refer to section 3.3.1 to 3.3.4 to install INF, Graphic, LAN and Audio drivers.
