System Installation
WADE-8070 User’s Manual
3-2
Memory frequency / CPU FSB synchronization
WADE-8070 supports different memory frequencies depending on the CPU front
side bus and the type of DDR2 SO-DIMM.
CPU FSB
Memory Frequency
533 MHz
533/400MHz
3.3
Installing the Single Board Computer
To install your WADE-8070 into standard chassis or proprietary environment, please
perform the following:
Step 1 : Check all jumpers setting on proper position
Step 2 : Install and configure CPU and memory module on right position
Step 3 : Place WADE-8070 into the dedicated position in the system
Step 4 : Attach cables to existing peripheral devices and secure it
WARNING
Please ensure that SBC is properly inserted and fixed by mechanism.
Note:
Please refer to section 3.3.1 to 3.3.7 to install INF/VGA/LAN/Audio drivers.
3.3.1
Chipset Component Driver
The chipset on WADE-8070 is a new chipset that a few old operating systems might
not be able to recognize. To overcome this compatibility issue, for Windows
Operating Systems such as Windows 2000 /XP, please install its INF before any of
other Drivers are installed. You can find very easily this chipset component driver in
WADE-8070 CD-title.
3.3.2
Intel Integrated Graphics GMCH Chip
Using Intel® 945GSE GMCH with Media Accelerator (GMA) 950 graphics integrated
chipset is aimed to gain an outstanding graphic performance. Shared 8 accompany it
to 128MB system DDR2-SDRAM with Total Graphics Memory. This combination
makes WADE-8070 an excellent piece of multimedia hardware.
With no additional video adaptor, this onboard video will usually be the system
display output. By adjusting the BIOS setting to disable on-board VGA, an add-on
PCI-Express by 1 VGA card can take over the system display.
