Troubleshooting
WADE-8011/WADE-8012 User’s Manual
5-1
Chapter 5
Troubleshooting
This chapter provides a few useful tips to quickly get WADE-8011/WADE-8012
running with success. As basic hardware installation has been addressed in Chapter
2, this chapter will primarily focus on system integration issues, in terms of BIOS
setting, and OS
5.1
Hardware Quick Installation
ATX Power Setting
Unlike other Single board computer, WADE-8011/WADE-8012 supports ATX only.
Therefore, there is no other setting that really needs to be set up. However, there are
only two connectors that must be connected—J10 (4 pins CPU +12V main power
connector) & J13 (24 pins ATX Power Connector) Figure.
Serial ATA Hard Disk Setting for IDE/AHCI
Unlike IDE bus, each Serial ATA channel can only connect to one SATA hard disk at a
time; there are total six connectors, J18, J19, J20, J21, J22 and J23. The installation of
Serial ATA is simpler and easier than IDE, because SATA hard disk doesn’t require
setting up Master and Slave, which can reduce mistake of hardware installation. All
you need to operate IDE and AHCI application for system, please follow up setting
guide in BIOS programming (Table 5-1); Furthermore, you can consult chapter 4.3
Advanced “SATA Configuration” part of the” SATA Mode”.
Table. 5-1 SATA Mode setting guide
