BIOS Setup Information
ROBO-8913VG2AR User’s Manual
4-35
Memory Remap Feature
Enabled: Allow remapping of overlapped PCI memory above the total physical
memory. Disabled: Do not allow remapping of memory.
The choice: Disabled, Enabled.
DRAM Frequency
Users are recommended to use Auto for memory frequency selection.
The choice: Auto, 533, 667, 800, 1067 MHz.
Configure DRAM Timing by SPD
This option provides DRAM plug-and-play support by serial presence detect (SPD)
mechanism via the system management bus (SMBUS) interface.
The choice: Disabled, Enabled.
Memory Hole
In order to improve performance, certain space in memory is reserved for ISA cards.
This memory must be mapped into the memory space below 16MB.
The choice: Disabled, 15MB-16MB.
Initiate Graphic Adapter
Select which graphics controller to use as the primary boot device.
The choice: IGD, PCI/IGD, PCI/PEG, PEG/IGD, PEG/PCI.
Internal Graphics Mode Select
Select the amount of system memory used by the internal graphics device.
The choice: Enabled, 1MB, Enabled, 8MB.
PEG Port
This setting allows you to select whether to use the on-chip graphics processor or the
PCI Express card. When set to [Auto], the BIOS checks to see if a PCI Express
graphics card is installed. If it detects that a PCI Express graphics card is present, the
motherboard boots up using that card. Otherwise, it defaults to the onboard graphics
processor.
The choice: Auto, Disabled.
StockCheck.com
