ROBO-6911VG2AR
Copyright © Portwell 2017 ROBO-6911VG2AR User's Guide
84
7 Troubleshooting
This chapter provides a few useful tips to quickly get ROBO-6911VG2AR running with success. As basic hardware installation has been addressed in Chapter 2,
this chapter will focus on system integration issues, in terms of BIOS setting, and OS diagnostics.
7.1Hardware Quick Installation
ATX Power Setting
Unlike other Single board computer, ROBO-6911VG2AR supports ATX only. Therefore, there is no other setting that really needs to be set up. However, there
are only two connectors that must be connected—J8 ATX 4 Pin Connector & 24 pins ATX Power Connector (On PICMG Backplane).
Serial ATA Hard Disk Setting for AHCI/RAID
Unlike IDE bus, each Serial ATA channel can only connect to one SATA hard disk at a time; there are total four connectors, SATA0~3 port. The installation of
Serial ATA is simpler and easier than IDE, because SATA hard disk doesn’t require setting up Master and Slave, which can reduce mistake of hardware
installation. All you need to operate AHCI, RAID (0/1/5/10) application for system, please follow up setting guide in BIOS setup utility.
