Trouble Shooting
ROBO-6710/6730VLA User’s Manual
5-4
AT Power Setting
This section will introduce you how to quickly and appropriately set up AT power
on your system.
Step 1: If you were currently using ATX mode, please remove 4 pins power cable
from the 5VSB Header For ATX and from the backplane, and then put a
jumper back on pin 3 (PS-ON) and pin 4 (GND) of Backplane ATX P/S
control connector. (Figure 5-7) Basically, our backplane products have the
default setting to set the jumper on the AT mode.
Figure 5-7
Step 2: Please adjust AT/ATX Jumper on “ JP1” to short 1-3, 2-4 pins, then it can
support AT power scheme. (Figure 5-8)
Figure 5-8
