System Installation
PEB-2737VLA User
’s Manual
3-2
3.3 Main Memory
PEB-2737VLA provides one 200-pin DDR2 SO-DIMM socket which supports
400/533 DDR2-DRAM as main memory, Non-ECC (Error Checking and Correcting),
non-register functions. The maximum memory size can be up to 2GB capacity.
For system compatibility and stability, do not use memory module without brand.
Memory configuration can be either one double-sided DIMM in either one DIMM
socket or one single-sided SO-DIMM in socket.
Watch out the contact and lock integrity of memory module with socket, it will
impact on the system reliability. Follow normal procedures to install memory
module into memory socket. Before locking, make sure that all modules have been
fully inserted into the card slots.
Note:
To maintain system stability, don’t change any of DRAM parameters in BIOS setup
to upgrade system performance without acquiring technical information.
Memory frequency / CPU FSB synchronization
PEB-2737VLA supports different memory frequencies depending on the CPU front
side bus and the type of DDR2 SO-DIMM.
CPU FSB
Memory Frequency
533MHz
533/400MHz
400 MHz
400MHz
3.4
Installing the Single Board Computer
To install your PEB-2737VLA into standard chassis or proprietary environment,
please perform the following:
Step 1 : Check all jumpers setting on proper position.
Step 2 : Install and configure memory module on right position.
Step 3 : Place PEB-2737VLA into the dedicated position in the system.
Step 4 : Attach cables to existing peripheral devices and secure it.
WARNING
Please ensure that SBC is properly inserted and fixed by mechanism.
Note:
Please refer to section 3.4.1 to 3.4.4 to install INF/VGA/LAN/Audio drivers.
