DETAIL "B"
1
2
CAUTION - DURING ASSEMBLY OF THIS BACKSTOP, IT IS OF EXTREME IMPORTANCE THAT THE
BACKBOARD IS NOT DROPPED, IMPROPERLY TORQUED (BOLTS TIGHTENED BEFORE PLUMBING ALL
ATTACHMENT POINTS), OR THE GLASS SECTION BE ALLOWED TO CONTACT OR STRIKE METAL PARTS.
THE WARRANTY DOES NOT COVER BREAKAGE DURING INSTALLATION.
Unpack and identify all parts (refer to Parts List on page 4).
1.
BACKBOARD ASSEMBLY:
2. Position the unpacked glass backboard (#1) on its cardboard packing carton in front of portable backstop frame
assembly (#4). Remove two 3/8" x 1-1/4" long carriage bolts, 3/8" flat washers, 3/8" lock washers, and 3/8" hex nuts
from back of glass backboard.
3. It is recommended that at least three adults perform this step. Insert two 3/8" x 1-1/4" carriage bolts through the middle
slot on either side of the backboard mounting plate. Carefully lift backboard (#1) and position so that middle backboard
mounting slots are in alignment with the corresponding holes on the backstop mounting plate. See Detail “B”.
4. While backboard is in this position, secure in place using two (2) 3/8" flat washers, 3/8" lock washers, and 3/8" hex
nuts onto each 3/8" x 1-1/4" carriage bolt. Snug tighten only.
www.porterathletic.com
Copyright
2017 by Porter Athletic.
All rights reserved.
888-277-7778
7/23/2018
INST1835
Page 7 of 39
1835 Portable Basketball Backstop
Installation, Operation, and Maitenance Manual
Assembly & Setup
