20
Detail "L"
If additional goal height
adjustments need to be
made, the rear bearing
assemblies can be shifted
as shown.
BACKSTOP MUST BE LOCKED IN
THE TRANSPORT / STORAGE
POSITION AS SHOWN, BEFORE
MAKING ANY ADJUSTMENTS TO
GOAL HEIGHT
To lower goal height, shift
rear bearing assemblies
forward as required.
To raise goal height, shift
rear bearing assemblies
backward as required.
Rear
Mast
Loosen hardware only enough to allow
bearing assemblies to be shifted.
DO
NOT REMOVE HARDWARE
.
Retighten all hardware after
adjustments have been made.
3.
If necessary, additional adjustments can be
made at the REAR bearing assemblies (at the
lower end of the rear mast). See Detail "L".
To raise the goal height, the rear bearing
assemblies must be shifted backward. To
lower the goal height, the rear bearing
assemblies must be shifted forward. Loosen
the hardware only enough to allow the bearing
assemblies to be shifted.
DO NOT REMOVE
THIS HARDWARE
. Shift both bearing
assemblies as required, then retighten the
hardware. Unlock the backstop, raise it to the
playing position, and check the goal height.
Repeat this process until the 10'-0" +/- goal
height is achieved. When all adjustments are
completed, make sure the hardware that
secures the bearing assemblies to the base has
been securely retightened. See Detail "L".
