7
22.
DO NOT
use bits with screw tips. These
bits will pull the workpiece up from the
table and start to spin, causing a serious
risk of injury.
23.
MAKE SURE
the spindle has come to
a complete stop before touching the
workpiece.
24.
TO AVOID INJURY
from accidental
starting, always turn the switch “OFF” and
unplug the drill press before installing or
removing any accessory or attachment or
making any adjustment.
25. Be sure the chuck is tightly secured to
the spindle.
26.
USE ONLY THE SELF-EJECTING TYPE
CHUCK KEY
as provided with the drill
press. Tighten the bit securely in the
chuck. The chuck key can be thrown at a
high velocity if not removed, causing risk
for injury.
27.
DO NOT FORCE DRILLING
. The tool will
do the job better and safer at the rate for
which it is was intended.
28. If the bit binds in the workpiece, release
the on/off switch immediately. Unplug the
tool, then free the bit from the workpiece.
Do not try to free a jammed bit by starting
and stopping the tool.
29.
DO NOT
touch the drill bit or cuttings.
The drill bit and cuttings are hot
immediately after drilling.
30.
ALWAYS
shut off, unplug and lock the
drill press, if a lock in available, and store
the key.
