Porter-Cable PCXB515BG, Instruction Manual

Page: 15 / 24

15
8. Install the new wheel and make sure both
wheel flanges (10, 12) are in place with
the concave sides toward wheels.
9. To prevent wheel rotating, place a wood
wedge (13) (not supplied) between the
wheel and the wheel cover as shown in
Figure H.
Fig. H
10. Then, tighten the hex nut (9) by an
adjustable wrench.
NOTE: Do not overtighten the nut as this
can crack the grinding wheel.
10. Replace the wheel cover (7) and
screws (5).
11. Reinstall and adjust the tool rest to
1/16 in. (1.6 mm) away from the wheel
and tighten securely.
12. Adjust the eye shield (1) to a point
between your eyes and the wheel.
MOUNTING THE TOOL ON A
WORKBENCH (FIG. I)
NOTE: We highly recommend that you bolt
this bench grinder securely to a workbench to
gain maximum stability for your machine.
1. Using the base of the bench grinder as
a template, mark the bench through two
holes (1) in the casting.
2. Bolt the bench grinder on the bench with
bolts, washers and nuts.
NOTE: The mentioned fasteners are not
supplied with the machine.
Fig. I
TRANSPORTING THE GRINDER (FIG. I)
To reduce the risk of injury, turn off the
grinder and disconnect it from power
source before installing and removing
accessories, adjusting and making repairs.
An accidental start-up can cause injury.
In order to conveniently carry the bench
grinder from place to place, hold the left
and right side of the grinder base (2) for
transportation.
CHANGE BATTERIES (FIG. J)
Unplug your saw. Failure to unplug your
saw could result in accidental starting and
causing possible serious personal injury.
1. Bag “G” - Remove the battery cover (1).
2. Install two AAA batteries into the case (2).
3. Replace the battery cover (1).
Fig. J
9
13
tighten
1
2
1
WARNING
!
WARNING
!
1
2