12
• Some accessories, such as scrapers
and blades can be mounted at an angle if
required as shown in
figure 7
.
Installing/Removing Sanding Sheets - Figure 8
A diamond shaped platen uses a hook
and loop adhesion system to attach the
sanding sheets. The platen allows you to
use it on large flat surfaces and tight
spots or corners.
• Attach the sanding platen as described
under “Installing/Removing Accessories”.
• Align the edges on the sanding sheet,
with the edge of the sanding platen and
press the sanding sheet onto the platen.
• Firmly press the base with the sanding
sheet attached against a flat surface and
briefly switch the tool on. This provides
for good adhesion between the platen
and the sanding sheet and also helps to
prevent premature wear.
• When the tip of the sanding sheet
becomes worn, detach the sheet from
the platen, rotate and reapply.
OPERATION
Switch
CAUTION:
Because the PCC510 has a separate speed dial for setting the speed
(7,500 -15,000 OPM), the tool will start at the speed where the speed dial was
previously set. Be sure switch is fully OFF before inserting the battery into the tool.
NOTE:
If battery is removed from tool
without turning switch OFF, the tool will
not start again until the battery is
replaced and the switch is turned OFF
and then ON again.
• Insert the battery into the tool.
• To turn the tool ON, hold it as shown in
figure 9
and push the slide switch
forward.
• To turn the tool OFF, push the slide
switch backward.
8
9
7
90582820 PCC510 18V OScillating Tool manual.qxd:??????-00 Cir Saw book 12/13/11 9:12 AM Page 12
