12
7. Mount the door plate (12) to the R.H.
side plate (3) hinges and fasten with four
screws w/ washers (10).
NOTE:
Hinge goes behind side plate lip.
8. Place stand on level surface and adjust
the feet if needed.
NOTE:
Make sure all screws and nuts are
tight and stand is on a stable surface before
mounting saw.
Although compact, this saw is heavy and
should be lifted with care. If needed, get the
assistance of someone to lift and move the saw.
ASSEMBLING BAND SAW TO CABINET
STAND (FIG. B)
1. Lift the saw body (1) and place on the
stand (2), aligning the mounting holes (3)
of the saw base with the four mounting
holes on the top plate of stand.
2.
Bag “D” -
Attach the band saw to the
stand with four long hex head bolts (4)
and four flat washers (5).
3. Place a flat washer (5) and hex nut (6)
on each bolt from the underside of the
top plate.
4. Hold bolt head with a separate wrench
and tighten all mounting bolts and nuts
with a wrench.
10
12
3
1
4
5
3
2
5
6
Front
Fig. A-5
WARNING
!
Fig. B
INSTALLING THE SAWDUST PORT (FIG. C)
The sawdust port has a 2-1/2 in. (63.5 mm,
O.D.) / 2-1/4 in. (57.2 mm, I.D.) diameter
opening, suitable for attaching to a wet/dry
vacuum hose to help keep the work area free
of sawdust.
1. Open the lower cover (1).
2.
Bag “E” -
Attach the sawdust port (2) to
the edge of the wheel cover, using the
hex head bolts (3) and washers (4).
3. Tighten the bolts (3) and close the cover.
ASSEMBLING THE BAND SAW TABLE
(FIG. D, E, F)
Mounting the trunnion support bracket
(Fig. D)
1. Place the trunnion support bracket (1) on
the saw body as shown, then align the
mounting holes.
2.
Bag “F” -
Place the washers (2) on the
hex head bolts (3), and insert into the
threaded holes, through the bracket and
saw body. Tighten the bolts.
3. Thread a nut (4) into the table stop
bolt (5) and the rear tab (6) on the
trunnion support bracket (1).
4. Tighten the nut down onto the bracket tab.
3
2
6
1
5
4
Fig. C
2
3
4
1
Fig. D
