Converting to another type of gas
8
7
30 di 3
1
GAS TRANSFORMATIONS AND ADJUSTMENTS
Replacing the nozzles
If the equipment is adjusted for a type of gas that is
different from the original, it is necessary to replace
the burner nozzles as well. The nozzles used to
replace the original must be in accordance with the
table of the technical characteristics enclosed.
To remove the racks and burners by means of a
straight spanner ‘L’, unscrew the nozzle ‘U’ (Fig.7)
and substitute it with the corresponding one and
tighten the nozzle.
Adjusting the burners
The flame should always stay alight when the
burner is switched on, even if there is an abrupt
shift from the maximum to minimum flame position.
If the flame does not stay alight, adjust it as
follows:
– Start the burner
– Turn the tap up to the minimum position (small
flame)
– Remove the knob from the tap rod
– Using a flat-tip screwdriver ‘C’ into the hole ‘F’ of
the tap (fig.8) turn the by-pass screw up.
CAUTION
Before proceeding with the conversion, shut off the gas supply to the appliance Prior
to disconnecting the electrical power.
THIS APPLIANCE WAS CONVERTED ON
DAY……..MONTH……..YEAR……..
TO GAS…………….. ( NAME AND ADDRESS OF ORGANIZATION MAKING THE
CONVERSION) WITH KIT SUPPLIED BY THE FACTORY, WHICH ACCEPTS THE
RESPONSABILITY THAT THIS CONVERSION HAS BEEN PROPERLY MADE