Porter & Charles CC30S, Operation Manual

Page: 12 / 16

12
Installation Instructions
WARNING
The operations indicated below must be followed by qualified personnel,
in conformity with the regulations in force.
The supplier refuses all responsibility for damages to person or property,
resulting from the failure to comply with such provisions.
INSTALLATION
All units are 230/240 power and 60hz
The appliance is designed to be embedded into heat resistant pieces of furniture or kitchen cabinetry.
Make the hole in the top of the piece of furniture with the dimension indicated in fig. 4 at a distance of at least
50mm from the appliance border to the adjacent walls.
Adhesive washer “S” along the border of the top bottom (fig.5)
Stabilise it with the fastening hooks “C” (fig.6)
ELECTRICAL CONNECTIONS (FIG.7)
Before carrying out electrical connection be sure that the characteristics of the electrical system meet the
specifications located at the bottom of the cooktop and the electrical system is provided with effective ground in
compliance with the regulations and provision of the law in your country.
The ground is required in all circumstances.
If you wish a direct connection to the line, it is necessary to use a single pole switch, with a minimum opening
between the contacts of 3 mm. suitable for the purpose and in conformity with the rules in your country (the
yellow/green ground cable should not be interrupted by the switch).
ATTENTION
Should a built-in oven or any other appliance producing heat be fitted directly
under a glass ceramic cook-top with touch control, it is recommended to insulate
the hob with a separator which is usually a piece of temperature resistant
timber. The operating temperature of the cooktop must be below 60°C.
Disregard of this precaution could cause the incorrect operation of the touch
control system of the cooktop and effect the product warranty provisions.