Porter & Charles CC30S, Operation Manual

Page: 10 / 16

10
heating element will switch itself off automatically. The corresponding display (5) also switches off or shows an
“H” to indicate residual heat and the timer alarm is activated.
Alarm mode: if no heating element is selected, the “t” on the displays (5) disappears, enabling the user to set the
timer value. After the programmed period has passed, the alarm will be activated although no heating element
will switch itself off automatically. When this mode is selected, the decimal point on the timer display
will be switched off.
General switch off
The cook top can always be switched off; regardless of the mode of operation it is, by touching the On/Off
sensor (Key 6) for 1 second. On switching off, there is a beep signal and the displays are turned off, unless there
has to be an “H” for residual heat on any display.
Special Notes
If the Keys for (+) or (-) (Key1) of an element are touched together, the element turns off (display at 0). If the
keys touched simultaneously are not of the same element the keyboard is locked and no operation is allowed.
The On/Off function prevails if 2 keys are touched at the same time, but only to turn off.
If all the cooking levels are at position 0, the control will turn off automatically after 10 sec. If a sensor is pressed
for more than 10 sec., the control will automatically turn off and a “beep” will sound every
30 sec., while the sensor is pressed.
Cleaning
Remove leftover and grease or spillage from the cooking surface with the special scraper (fig.3) (optional).
Then clean the heating area thoroughly with a paper towel and ceramic cleaning products for the correct care of
your appliance. Never use abrasive sponge or irritating chemical detergents such as over spray or spot
removers.