Portek Post Driver, Operator'S Handbook Manual

Page: 15 / 20

15
Spare Parts
A full range of spares are available. Please contact your Portek Dealer to request
replacement parts.
Problem Possible Cause Remedy
Difficulties in starting
engine in cooling state.
Not enough fuel in fuel tank Add fuel
Spark plug is wet Remove spark plug and dry
Spark plug is damaged Replace spark plug
Spark plug connector lose Check and secure
Spark plug gap incorrect Set gap to 0.025” (0.635mm)
Difficulties in restarting
after a sudden stop.
Not enough fuel in fuel tank Add fuel
Carburettor is blocked Check and clean
Fuel filter is blocked Replace fuel filter
High carbon deposits found
on spark plug Remove carbon deposits
from spark plug, clean filter
Slow speed
or weak power.
Air filter is blocked Replace air filter
Fuel tank feed pipe
or air vent blocked Check and clean
High carbon deposits found
in combustion chamber Remove carbon deposits
Abnormal sound
Damage or abrasion
to active components Replace worn parts
High carbon deposits found
in combustion chamber Remove carbon deposits
Post Driver works
but not efficiently Rubber impact piston ring is
aged or worn Replace worn parts
Excessive smoke Wrong fuel mixture Drain fuel and replace
WARNING! Operating problems are often due to causes that the user
can fix. Therefore check the product using this section to eliminate
these simple issues. In most cases the problem can be solved quickly.
!
WARNING! Only perform the steps described below! All further
inspection, maintenance and repair work must be performed by an
authorised service centre or a similarly qualified specialist if you cannot
solve the problem yourself! IF IN DOUBT SEEK EXPERT ADVICE
!
Troubleshooting & spare parts