Porsche PCCM Plus, Technical Information

Page: 5 / 12

Technical Information
911 (996)
56/20
ENU
9112
9
2.1
2.1 Route wire harness for heating/air-condi-
tioning control panel

2.1 from the instal-
lation opening  2.1 in the dashboard to
the installation slot

2.1
-C -
in the center
console and secure it.
2.2 Pull insert sleeves off old trim for heating/air-
conditioning control panel and insert them
into the heating/air-conditioning control panel
 2.2 .
2.3 Insert connector into heating/air-conditioning
control panel.
2.2
2.4 Insert heating/air-conditioning control panel

2.2 into the lower installation slot of the
center console and secure with screws  2.2
-C -
.
NOTE: Use new screws (Torx 4 x 20, see
parts list).
2.5 Insert rear retaining bar  2.2 for PCM2 and
secure with screws
3 Remove A-pillar at the right.
Figure 7
3.1 On all vehicles without M440, route adapter
cable from antenna  Figure 7 -2- to PCCM
Plus radio slot.
Disconnect windscreen antenna from the
antenna amplifier

Figure 7 -2- . Connect

Figure 7 -5- windscreen antenna to adapter
cable

Figure 2
-10-
.
Loosen screw  Figure 7 -3- and install
ground line

Figure 7
-4-
. Tighten the screw
again.
AfterSales
Aug 31, 2020
Page 5 of 12
2 Conversion of air-conditioning control panel