55
“Diag Control Light”:
The “Diag Control Light” is controlled by electronic errors (sensors)
which occur at a particular frequency, or are permanently active. The
lamp indicates MS3.1 system errors.
A special software programme is required to delete the errors (Bosch
Modas), which must be purchased form Porsche Motorsport.
Fuel pump switch:
Position “Service”
The pump runs with the ignition (only to drain any remaining fuel in the
tank).
Position “Bosch”
Pump only runs when the engine is running.
Data logging:
Motec Display with 1 Mb data logging memory.
Option:
•
Steering angle sensor in connection with 2 Mb memory
Interface:
CAN: When using the CAN interface in connection with a data acquisition
system (not Motec) the terminating resistor must be re-located.
The Cup Motec System is distributed exclusively worldwide by
Brückle – Motorsport.
If you require information or a system please contact
Brückle – Motorsport directly.
Information directly from:
Brückle - Motorsport
Consulting GMBH
Werner Brückle
Zennerstr. 29
D 81379 München
Tel. +49 89 72308198
Fax +49 89 72308199
E – Mail :
