Pop ProSet PB2500, Service Manual, Page: 13 / 37

12
3. Tool Use & Set up
The PB Series of tools are designed for installation of STANLEY Engineered Fastening Blind
Fasteners.
DO NOT use under wet conditions or in presence of flammable liquids or gases.
READ ALL SAFETY WARNINGS AND INSTRUCTIONS BEFORE PUTTING TOOL INTO SERVICE.
Electrical Safety
The electric motor has been designed for one voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Your DeWalt/POP-Avdel charger is double insulated in accordance with EN60335;
therefore no earth wire is required.
Using an Extension Cable
An extension cord should not be used unless absolutely necessary. Use an approved extension
cable suitable for the power input of your charger (see Technical Data). The minimum
conductor size is 1 mm2; the maximum length is 30 m.
When using a cable reel, always unwind the cable completely.
Before Use
• Select relevant size nose equipment and install
• Ensure that the battery is fully charged
• Insert Battery Pack into the tool
•Quickly pull and release the trigger to set the tool to the home position.
4. Operating Instructions
ALWAYS wear approved hearing and eye protection at all times when using
installation equipment
WARNING: Before adjusting tool, always remove the battery pack.
4.1. NOSE EQUIPMENT
Mounting the nosepiece (fig. 7).
• Select the correct nosepiece for the rivet to be installed. Ref. Nose Piece chart.
• Tighten the nosepiece into the nose housing (B) by turning it clockwise using 11 mm spanner.