No Diving or Jumping. Observe all Safety Rules.
4
3-4
14
Hint:
If possible, unfold the
liner on the grass one
to two hours before
installation.
Be careful
not to leave the liner
too long or you may
damage the grass.
15
16
17
Hint:
To smooth out the
wrinkles in step 2(c),
use a
vacuum cleaner
:
block the skimmer
outlet with card-
board and tape and
put the vacuum hose
through the skimmer
return hole, between
the liner and pool
wall. Seal the hole
with tape and keep
the hose 4" to 6" (10
to 15 cm) above the
sand cove so you
don’t suck up any
sand. Start the vac-
uum and run it until
most of the wrinkles
are gone. Then, stop
the vacuum and add
1" (2.5 cm) of water
to the pool. Finally,
remove the vacuum
hose and unplug the
skimmer hole.
B. Install your Pool
Liner
1. Set the liner in place
a. Open the carton.
Do not
use
anything sharp to open the
carton.
b. Unpack and unfold the liner
and spread it out in the sun
to warm it up. Inspect all the
seams and surfaces for holes.
c. Spread out the liner, smooth
side down. The curved seam
should be centred on the
cove at the base of the wall.
The other seams will form
straight lines across the bot-
tom of the pool.
d. Smooth out all the wrinkles in
the bottom.
2. Fasten the Liner in place
(Overlap Liner only)
This step applies only if you
have an Overlap Liner. See
the next page if you have a
Beaded Liner or V-Bead Lin-
er.
a. Lift the sides of the liner and drape them over
the top of the pool wall. If you have a 52" (132
cm) high pool, pull the liner up until there is
2" (5 cm) overhang; if you have a 48" (122 cm)
high pool, pull the liner up until there is 6" (15
cm) overhang.
b. If you are using stabilizer, pack it around the wall to from a cove
of about 15cm high and 15cm wide at ground level. Wet the sand
to pack it and use a trowel to spread it evenly.
c. Wet the sand on the floor of the pool to smooth it. Pack it using a
manual compactor.
d. If you are using polypropylene pieces, insert them in the lower
wall channels of the pool.
