15
HomeLink
®
Transmitter
This programmable transmitter can store
up to three frequencies for many
remotely operated items.
Programming the Transmitter
With the ignition OFF, program the
transmitter as follows:
1. Press and hold down the two outside
buttons until the indicator light flashes
and then release the buttons (about
20 seconds — do not hold for more
than 30 seconds); do not repeat this
step for the second or third devices
to be added to the system.
2. Hold your hand-held transmitter
near the surface of the HomeLink
®
transmitter. Then hold the button on
the hand-held unit and the button on
the HomeLink
®
transmitter you will
assign it to.
3. Continue holding both buttons (up to
90 seconds); the indicator light will
begin blinking slowly and then more
quickly. Programming is complete
when the light on the HomeLink
®
transmitter flashes rapidly.
4. Release both buttons; then press and
hold the HomeLink
®
button again. If
the indicator light remains lit, pro-
gramming is complete.
To program the remaining two
HomeLink
®
buttons, begin with Step 2
(above). Do not repeat Step 1, as this
will erase all of the programmed
channels.
See Section 2 of your Owner Manual.
Note:
If the HomeLink
®
indicator light
blinks rapidly for two seconds and
remains on, it indicates that your device
(usually a garage door opener) has a
“rolling code.” See your Owner Manual.
