9
SV203
- Commands Descriptions
BDn
Select Board
Before the board will accept any commands, it must first be
enabled. To enable the board, you must send the BD command
followed by the board ID number (n). The default ID number of the
board is 1. So simply send the following to enable the board:
BD1 <enter>
The board ID number can be user-redefined by using the WE
command (see Commands Descriptions Page – p.20). This allows
multiple boards of different ID number to be connected to the same
serial port.
You can enable the board in two other ways: You can pre-enable
the board at power-up by changing the default settings. (see
Changing Default Settings Page – p.22); or you can enable the
board by sending an ID number 0, such as:
BD0 <enter>
This will override the ID number checking and any boards
connected to the port will be enabled regardless of the ID number
of the board.
