32
User Guide
Using Walk-and-Talk products
3. Press the “Projection” button on the remote control one time. The
following alignment window projects from the computer to the
board.
4. Using your finger, touch each target as it appears on the whiteboard,
following instructions you see in the screen.
When alignment is complete, you are ready to begin using your
computer and whiteboard in projection mode.
note:
NOTE:
The Projection LED at the lower left corner of the board glows yellow while
you are in projection mode.
note:
NOTE:
At startup, the PolyVision driver recognizes if you are using the IP and
automatically initiates projection mode. No alignment is necessary.
To exit projection mode:
Ŗ
Press the Projection button on the remote control.
The alignment between your projector and the PolyVision product is
important. PolyVision offers three levels of alignment: good, better, best.
The default is “best” alignment. If you need to change the correspondence
between the position of the cursor and the point of contact when you tap
the whiteboard, refer to "Choosing alignment accuracy" on page 63.
9A67)DQQMHO2CIG(TKFC[,WPG#/