IF YOUR POOL INCLUDED OPENINGS AND POOL WALL FITTINGS ONLY; YOU MUST INSTALL THOSE, THE WATER CAP AND THE
SERVICE PLUG BEFORE PUTTING ANY WATER IN YOUR POOL. PLEASE FOLLOW THE DIRECTIONS BELOW.
• IF YOUR POOL INCLUDES A COMPLETE FILTRATION SYSTEM WE RECOMMEND THAT YOU COMPLETELY INSTALL THE
ENTIRE FILTRATION SYSTEM FIRST BEFORE PUTTING ANY WATER IN YOUR POOL TO AVOID WATER LOSS.
• FOLLOW THE "SETUP INSTRUCTIONS" IN THE FILTER PUMP SYSTEM OWNER’S MANUAL TO INSTALL THE FILTRATION SYSTEM AND
THE POOL WALL FITTING(S) BEFORE PUTTING ANY WATER IN YOUR POOL.
• If your pool included openings or if you are going to purchase a filter pump system, position the Suction & Return fitting locations so they are 10 to
21 feet from the electrical outlet you plan to use for the pool pump.
• If your pool came with Fittings - Install both the Suction and Return fittings to the pool wall before filling the pool. Please Note: The Black Rubber
gasket (Fitting Gasket) should always be slid over the threaded plastic suction or return fitting and be on the inside before the fitting is placed
through the pool wall to make a watertight connection.
• Make sure to Put on both the Water cap and the Service Plug before filling your pool with water and leave them in place until you are ready to add
a filtration system.
16. Make sure the liner drain fitting is plugged securely and the cap is in place. Then start filling the pool with water until about 1-inch of water is on the bottom.
AFTER ABOUT 1-INCH OF WATER IS ON THE BOTTOM, STOP FILLING THE POOL AND COMPLETELY SMOOTH OUT ALL OF THE WRINKLES FROM
THE BOTTOM OF THE POOL, WORKING FROM THE CENTER OUTWARD. BE SURE THE FLOOR OF THE POOL IS COMPLETELY ROUND AND FLAT
AND THAT THE LEGS ARE COMPLETELY STRAIGHT AND VERTICAL TO THE GROUND. IMPORTANT: IF MORE THAN 1-2 INCHES OF WATER
COLLECTS ON ANY ONE SIDE BEFORE THE POOL STARTS FILLING IN THE CENTER, THE POOL IS NOT LEVEL ENOUGH, AND MUST BE CORRECTED.
ADDITIONAL NOTE: THE WEIGHT OF THE WATER WILL PREVENT ADJUSTMENT AFTER THIS POINT.
NOT FOLLOWING THE STEPS ABOVE WILL MAKE THE POOL FILL UNEVENLY AND THE POOL MAY LEAN TO ONE SIDE AND COLLAPSE
(SEE EXAMPLE ON PAGE 13 PICTURE #8). YOUR POOL SHOULD BE STRAIGHT AND VERTICAL TO THE GROUND. IF YOUR POOL IS LEANING AT ALL;
THE GROUND MAY NOT BE LEVEL AND YOU WILL NEED TO START OVER.
FAILURE TO FOLLOW THE INSTRUCTIONS ABOVE WILL CAUSE POOL TO COLLAPSE AND WILL VOID THE WARRANTY!
IMPORTANT: FOR POOLS THAT DO NOT COME WITH A FILTRATION SYSTEM.
IMPORTANT: FOR POOLS THAT INCLUDE A COMPLETE FILTRATION SYSTEM
11
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
MST. Extended operating days and hours during peak season requirements.
Fitting Lock
Nut
Suction Fitting
Washer
Fitting Gasket
Suction Fitting
Outside Pool Wall
Inside Pool
SUCTION FITTING
Service Plug
Water Cap
RETURN FITTING
Threaded Type
Return Fitting
Return Fitting
Diverter
Return Fitting Fitting Gasket
Fitting Lock Nut
Inside Pool
Outside Pool Wall