Boot & Slide Valve Assembly
Installing the Deluxe Slide Valve
The collars now bolt right on to the bottom of the cones there may need to be some trimming necessary .
There is a straight, a 30 degree and a 45 degree collar available
Hold the collar up to the cone and Drill 1/4
”
Holes about 2
”
apart, (the bolt pattern is marked on the
collar). Use 1/4
”
X 1
”
Carriage bolts from the inside out, place a washer and nut on to fasten in place. After in-
stalling the collar run a bead of caulking around the top of the collar to help seal out the rain. Bolt the slide
valve to the collar using 1/4
”
X 1
”
Carriage bolts. Use 4 down the sides and 2 on the ends. (the bolt pattern is
marked on the collar of the slide valve). If you add the boot with the slide valve use the same bolt pattern to
fasten the boot to the valve as you used to fasten the slide valve to the collar. (the bolt pattern is marked on the
body of the slide valve). But use 5 down the sides and 3 on the ends. There is a nylon bearing you can use to
help hold the auger shaft in place at the back of the boot. If the hole is to small drill it to the size you need.
.