Polychem PHT1401, Operation Manual And Spare Parts List

Page: 10 / 24

7) SERVICING - CLEANING
DISCONNECT TOOL FROM COMPRESSED AIR LINE BEFORE ANY SERVICE OR CLEANING
Periodically clean the tool from strap dust, particularly the feed wheel, the gripper plates and the
cutter. Use compressed air or a wire brush (do not use other tools or keys) (pic. F1,F2)
( F1 ) ( F2 )
Cutter replacement
Disconnect the air pipe from welding motor (pic.G1), remove the 2 locking motor screws (pic.G2),
remove the motor (pic.G3).Remove the cutter spring with pliers (pic.G4), put air in the disconnected
pipe to push down the piston to free up the cutter and then remove the cutter from its seat by using
pliers (pic.G5). Replace it and reassemble in reverse order putting grease on spring and cutter seat.
( G1 ) ( G2 ) ( G3 )
( G4 ) ( G5 )