ZONEMASTER UNIPOINT RF DAMPER CONTROL SYSTEM
- Owner’s Manual
Page
4)
NOTE: The action will not happen immediately.
The RF signal will be sent to the main control
module by pressing button, and the damper
of the selected zone will then change its status.
5)
Repeat step
2)
to
4)
to select another zone to turn
it on or off.
6)
Pressing button will exit the zoning mode.
Alternatively, it will return to the sleep mode itself
in 15 seconds with no key being pressed.
3)
Programming mode - On/off time control
Programmable on/off time control for each zone is an important feature of
the Zonemaster UniPoint RF system. This system has a 5-1-1 program
capability that means the system has an individual program for weekdays
(Monday to Friday), Saturdays and Sundays respectively.
The system allows you to create 4 separate programs and then allocate
any one of these to each of the (up to 8) zones.
Each of the 4 main programmes has 4 sub-programmable events per day:
On time 1, Off time 1, On time 2 and Off time 2. Each program event can
be enabled/disabled and their times can be adjusted as desired. All 4 sets
of sub-programs are disabled in the factory default with identical settings
as listed in the following table.
On time
Off time
On time 2
Off time 2
Monday to Friday
6.30AM
8.00AM
5.30PM
10.00PM
Saturday
7.30AM
12.30PM
6.00PM
11.30PM
Sunday
7.30AM
12.30PM
6.00PM
11.30PM
Summary of Contents for Zonemaster Unipoint RF
Page 1: ...UNIPOINT RF DAMPER CONTROL SYSTEM Owner s Manual Setup Guide ...
Page 21: ......
Page 22: ......
Page 23: ......
