Polyaire Zonemaster Unipoint RF, Owner’S Manual & Setup Manual

Page: 16 / 24

ZONEMASTER UNIPOINT RF DAMPER CONTROL SYSTEM - Setup Guide Page
5) The main control board will exit the setting mode after the button
not being pressed for 5s. When exiting, all the RED LEDs light up
for resetting all the positions.
6) Once the setting is finished, all the zone’s previous control
positions will be resumed.
6d) Number of zones in the system
For the purpose of zone status display and spill/bypass zone calculation,
the controller needs to know the total number of zones in the system. Its
factory default value is 8.
1) At the setting mode, select ‘Parameter’ by using
or button. Then press button until
the LCD displays the ‘Parameter’ screen.
2) Use arrows or button to scroll down to
‘Number’ line.
3) Press and button to adjust zone number
to the desired number of the system. The
selectable zone number is 1 to 8.
6e) Supply air safety high & low limits
For safety reasons, the system monitors the supply air temperature of the
system closely. If the temperature moves outside of the limits, all dampers
in the system are forced open. The factory default setting is that the safety
control is disabled.
1) At the setting mode in ‘Parameter’ screen, press
or buttons to select ‘Hi-limit’, and press
button to enable Hi-limit.
2) Once enabled, the Hi-limit shows 60°C as default
and it can be changed by pressing the and
buttons. The adjustable range of the high limit is
from 45°C to 75 °C.
3) Press or button once to select ‘Lo-Limit’,
and press the button to enable ‘Lo-limit’.
4) Once enabled, the Lo-limit shows 5°C as default and it can be
changed by pressing the and buttons. The adjustable range of
the low limit is from 0 °C to 15 °C.
5) NOTE: If customer does not want the safety function, no supply air
sensor should be installed. The safety limits must be disabled by
pressing the button once.