Polyaire Zonemaster Airtouch, User Manual, Page: 7 / 28

ZONEMASTER AIRTOUCH ZONE CONTROL SYSTEM - User Manual
5
4) Automated AC/Group Control
Automated on/off control for each group and the AC unit is an important feature of
the AirTouch system. This system has a program capability with three possible
program settings, one for weekdays (Monday to Friday), one for Saturday and one for
Sunday respectively.
Each program has 4 programmable events per day: on time 1, off time 1, on time
2 and off time 2. Each program event can be enabled/disabled and their time can be
adjusted as desired. All four sets of program are disabled in the factory default with
settings as listed in the table below.
NOTE: A group can have up to a maximum of 4 zones. Your installer would
have already set up your zones and groups.
3.3 Adjusting airflow for a group
• The damper opening percentage for every group can be adjusted to control
the amount of airflow at every outlet between 10% and 100% of the balanced
value (setup by Installer) at 10% increments.
• Touch or buttons on the home screen to increase or decrease the
percentage opening for the corresponding group.
• The airflow will be unadjustable if the Turbo function is active. Pressing
and will not change the opening percentage.
NOTE: The Turbo function cannot be programmed. It is activated manually from
the touch screen as needed.
On time 1 Off time 1 On time 2 Off time 2
Monday to Friday 6.30AM 8.00AM 5.30PM 10.00PM
Saturday 7.30AM 12.30PM 6.00PM 11.30PM
Sunday 7.30AM 12.30PM 6.00PM 11.30PM