3
I N S T A L L A T I O N
Mounting (Using Mounting Plate)
1.Choose a mounting location on the dash board or instrument panel that
will allow room behind to run radio cables to the power source. Consider
how you will use the AUX IN, LINE OUT and USB connectors and route the
appropriate extension cables to an accessible area.
2.Once you have determined a mounting location, you will need to cut a
circular hole 3.1875inches or 81mm in diameter. Cut-out template available
on page
15
. At least 3.75-inch depth is needed to mount the radio.
IMPORTANT! Do not mount this unit where it can be submerged in
water.
3.Slide the mounting plate over the backside of the unit and secure with the
supplied screws.
4.Press on the trim bezel to the front side of the unit.
5.Plug in all wiring harnesses and cables. Refer to the wiring diagram on
page
5
for wire harness connection types.
Summary of Contents for GSMR30
Page 5: ...5 W I R I N G D I A G R A M...
Page 16: ...16 NOTES...
Page 17: ...17...
Page 18: ...18...
