UM1
4
INSTALLATION
Before You Begin
Always disconnect the negative battery terminal
Important Notes
Before final installation, test the wiring connections to make sure the unit is connected
properly and the system works.
Consult with your nearest dealer if installation requires the drilling of holes or other
modifications to your vessel.
Install the unit where it does not interfere with operating the vessel and cannot injure
passengers.
Use the included template to cut the installation opening.
Commander Cover
During storage, use the included cover to prolong the life of your device by protecting
the wired commander from direct sunlight, moisture, dust, and other elements.
Wired Commander Mounting
Choose a mounting area for the wired commander that is clean and flat, allowing the
rear gasket to fully seal to the mounting surface.
Secure the wired commander using either of the recommended mounting methods
detailed below.
Bracket Mount
Insert wired commander through cut-out and secure with bracket using included
hardware as detailed in the diagram.
Screw Mount
Secure the wired commander to the mounting surface using #6 stainless steel pan
head screws (
not included
) as detailed in the diagram.
Bracket Mount
Screw Mount