P. 14
User Guide
Home Valet
TM
If this feature is installed, the user will have the possibility to remotely set the vehicle to a no-
remote-start mode. See
Home Valet
section, earlier in this Guide, for full instructions.
Ignition-controlled Door Locks
This is an added security feature. If your Systems was installed with the Ignition-Controlled Door
Locks option, the doors will automatically be locked as soon as the ignition key is turned to the
IGNITION ON (RUN)
position while the brakes are pressed. When the key is turned to the
OFF
position,
the doors will automatically be unlocked.
Ignition Re-lock
On Systems of this series, when Ignition-controlled Door Locks
are enabled and the ignition key is
in the
IGNITION ON (RUN)
position, should any door be unlocked and opened, all doors will be
relocked next time the brake pedal is pressed.
Secure Lock
Before it can remote-start your vehicle, the System must first disarm the factory security system.
The Secure Lock feature may be required on certain vehicle models with factory security systems
that automatically unlock the doors when the security system is disarmed.
To keep your vehicle protected when the factory security system is disarmed for a remote start,
Secure Lock will relock your doors as soon as the vehicle has started. Once the engine run cycle
ends, Secure Lock will rearm your factory security system.
Turbo Mode
When left in Turbo Mode, the System will keep the engine running for 60 seconds before shutting it
down. This is to allow a turbocharger to idle down after the user leaves the vehicle. See
Turbo
Mode
section earlier in this Guide.
Remote Trunk Release
If your system was installed with the Remote Trunk Release option, you can open your trunk by
pressing the
TRUNK
button for 3 seconds on the remote transmitter or by pressing the
TRUNK
button
TWICE
within 3 seconds.
Engine Run Time
If you have a gas engine, your System can be programmed to run the engine for 4, 15, or
25 minutes (15 minutes by default). If you have a diesel engine, the System can be programmed to
run the engine for 9, 20, or 30 minutes (20 minutes default).
Multi-car Operation
This option allows the owner of two vehicles, both equipped with System systems, to control both
systems with a single remote control. To control the second vehicle, simultaneously press the
TRUNK
button and the button of the function you wish to use. See the transmitter operation table
earlier in this Guide. for full instructions on second car operation.
Note:
Your remote control must be configured for second car operation by the installer.
L.E.D. Intrusion Codes
If an intrusion took place while your vehicle was locked and the system was armed, the L.E.D. will
provide feedback on the intrusion. The L.E.D. intrusion codes are flashed by the L.E.D. in
continuous loops and are as follows:
