17
DIAGNOSTICS - PARKING LIGHTS FLASH RATE (NORMAL OPERATION)
TESTING
Before putting back the vehicle together, it’s a good idea to check that the system operates properly. The following testing
procedures should be used to verify proper installation and operation of the system. Before testing, make sure that all
connections are soldered and that the unit is plugged in.
1.
Test Hood-Switch shutdown
: with the vehicle running under the Remote Starter, open the Hood; the vehicle should
shut down. If it does not shut down, check the Hood Switch and its connector.
2.
Test the Brake shutdown circuit
: With the vehicle running under remote, press and release the Brake Pedal. The
Engine should shut down immediately. If the Engine continues to run, check the Brake Switch connection.
3. Test all functions for proper timing and operation.
4.
Remote-START the Engine and listen for Starter drag.
If the Starter cranks too long, go through another TACH
learn.
CLOSING UP
Use tie-wraps or screws to properly secure the starter Module and keep the wiring away from any moving parts such as the
Parking Brakes or Steering Column Shafts. Mount all switches in a good and accessible location where they do not risk
getting kicked or hit accidentally. Take the time to properly explain all functions and features to the customers before they
leave the premises. Most comebacks are the result of misunderstandings about how a product works or performs. Doing this
will save time and money. Always make all your connections before plugging in the Module, and be sure to test all functions
properly before closing up the installation.
FLASHES DESCRIPTION
1
x
Doors locked
x
End of run time
x
Run time cancelled
x
Trunk opened
x
Cancelled cold weather
x
Or cannot start after maximum attempts of tries
2
x
Doors unlocked.
3
x
Entering Cold Weather Mode
x
Tach watch lockout.
4
x
+12 volts where detected on the brake line and cancelled cranking
5
x
New Transmitter learned
x
Tach learnt
6
x
Remote start attempt was made with a Tach or a vacuum signal detected
8
x
Unit Reset: Occurs when the unit is reset to factory default
10
x
The Hood line went to ground during crank or run time
ON 2 sec.
x
The Hood opened and the Hood switch line went to ground. This is step one of the Programming Mode.
ON 5 sec.
x
The end stage of the procedure to program Transmitters.
ON 20 sec.
x
If the Hood Switch is flashed twice (
down-up-down-up
): the unit went into step 1 of the programming
cycle.
ERRATIC
x
If the unit flashes erratically (1 to 9 flashes followed by a pause, followed by more flashes), it is in
Playback Mode. This occurs when the Hood-Switch line is flashed 3 times (
down-up-down-up-down-up
).
Summary of Contents for PS-3025 SH
Page 6: ...6 WIRING DIAGRAM ...