10
FUNCTION 3 –AUX 2
OPTION 1
Constant while pressed (LOCK & UNLOCK pressed simultaneously) or START in Safe Start Mode
OPTION 2*
Toggle ON / toggle OFF with timeout up to 30 seconds
OPTION 3
Toggle ON / toggle OFF with timeout up to 60 seconds
OPTION 4
Priority Door Access
FUNCTION 4 - AUX 1
OPTION 1
Horn Confirmation on 2nd LOCK
OPTION 2*
Priority Door
OPTION 3
Horn Confirmation when LOCK
FUNCTION 5 – External Trigger Sense
OPTION 1
Zone 3 (Trunk pin) rearm (controls rearm timing)
OPTION 2*
Engine START / STOP
OPTION 3
Key Sense
OPTION 4
Dome Light-controlled Smart Ignition LOCK
2
nd
IGN / ACC / CRANK RELAY OUTPUT
PS-3025 SH-series car starters are equipped with a high-current, programmable 5
th
relay onboard that can be used to power a
second Ignition, Accessory, or Crank wire.
The unit uses a series of 3 jumpers; each jumper represents a function. In order to activate any one of the three possible 2
nd
outputs, you must place the jumper (supplied) on one of the three sets of pins, and simply connect the 14-AWG wire to the
second Ign / Acc / Crank wire of the vehicle.
NOTE:
x
ONLY ONE OF THE THREE SETS OF JUMPERS CAN
BE USED AT ONE TIME.
x
The relay output rating on this unit is 25A at most.
Defective OEM solenoid switches can sometimes draw up
to 50 or 60A, causing the 30A fuse to blow. Using a digital
voltmeter, check the Starter wire for voltage draw when
vehicle is cranking.
PROGRAMMABLE FEATURES
The following features can be programmed according to installation needs and the requirements of the user.
Lock Pulse Duration
(Mode 1 – Function 4)
x
7/10-sec. LOCK and 7/10-sec. Unlock pulses by default.
x
4-sec.
lock/unlock outputs to control vacuum Door Lock systems (i.e.: Mercedes)
x
A single 7/10-sec. LOCK pulse and
two 1/2-sec
UNLOCK pulses. (Used for double pulse disarm/unlock systems
i.e.: Maxima, Pathfinder, Volkswagen…)
x
Or 1/10 sec LOCK and 1/10 sec Unlock pulses.
Vehicle Type – Gas or Diesel
(Mode 2, Function 4) Set to Gas Mode by default, the unit can be programmed to operate in Diesel Mode. In Diesel Mode the
system will wait for glow plug light to go out for up to 15 seconds, before cranking the Engine. Note that the run time is
automatically extended when Diesel Mode is selected.
Horn Confirmation
(Mode 3 – Function 4 – OFF by default.) AUX 1 can be programmed to activate the Horn every time the LOCK button is
pressed, or when the LOCK button is pressed twice within a 3-second delay
. When Horn Confirmation is activated, Panic
Mode is enabled.
Summary of Contents for PS-3025 SH
Page 6: ...6 WIRING DIAGRAM ...
